Hi, I am currently performing the Network+ IPv4 and IPv6 addressing lab. I am on Exercise 2 - Setup Network Connectivity between IPv4 and IPv6 devices -Task 4 - Enable ISATAP on an IPv4-only Domain Server -Step 3. I am a little confused at his part
"From the results displayed, notice the following:
- The alpha-numeric values of the isatap. {interface_index} for the Tunnel adapter on this server is the same as was noted on the PLABSA01 which is the ISATAP router. This confirms that the ISATAP router is providing the addressing information to the ISATAP-enabled server." It says the alphanumeric value should be the same but the PLABSAO1(ISATAP router) is not the same as the PLABDCO1 tunnel Adapter.
PLABSAO1 shows
and PLABDCO1 shows
However, even in lab instructions they are different.
PLABSAO1 is displayed as
but PLABDCO1 is displayed as
I am confused because they say it is the same but even in the lab pictures they are different because the DCO1 ends in 33 and the other PLABSAO1 ends in 34. I don't know if I am missing something or not. Any clarification would be appreciated. Thank You.