Save
Saving
  • M
    Michael Sciocchetti

    Thank you Ronnie for the quick reply! I will check into the version number on the next one I change out.

    posted in Cisco read more
  • M
    Michael Sciocchetti

    I noticed sometimes when I setup a new switch at my desk with a production config including IP info, VTP Domain and client info and then save my config. When I get to the install site and boot the switch sometimes it saved my VTP config info and sometimes it reverts back to server mode?? VTP domain is correct though. I have been booting the switch on console to verify the VTP domain and mode before connecting to my production network. I don't see this every time and I haven't pinpointed the reason. I suspect it has something to do with the way I paste my base config to the switch. Usually I just xmodem the config over since I am mostly replacing an older switch or a RMA switch. Then make my small changes. Anyone know why the VTP mode switches back to Server after I set it to client?

    posted in Cisco read more
  • M
    Michael Sciocchetti

    Did you get this resolved? I'm having the same issue. Thank you Mike

    posted in General Discussion read more